How to String a 9-Diamond Top String
Your top string is the first step toward a pocket you can trust. It holds the mesh in place across the scoop and gives you a solid starting point for the sidewalls. In this guide, we’re breaking down Greg’s nine-diamond top string so you can follow along one connection at a time.
Grab your head, mesh, and top string. Keep Greg’s video handy so you can pause and check the string path as you go.
Watch the full 9 Diamond Top String tutorial
To get started, you will need the following items:
- Men’s lacrosse head
- A piece of Hero 4.0 Mesh
- A top string
- A pair of scissors
- A lighter
1. Get Your Mesh Ready
First, you are going to begin by stretching the mesh out. Make sure to stretch it out evenly to break it in a little bit.
Start by finding a nine-diamond row near the top of your mesh. Fold the mesh so that row becomes your top edge, with the diamonds lined up neatly.
Count all nine diamonds before you start. You’ll use the outside diamonds to anchor the mesh at each side and space your scoop attachments evenly between them.

Follow along with Greg from 0:58
2. Anchor the First Side
Tie an Anchor knot at the end of your top string and feed it through your starting sidewall hole. Attach the outside diamond of the folded mesh to that hole, from front to back, then back through the sidewall to create a loop.
Pull the connection tight before moving across the scoop. This anchor sets the starting point for the rest of your top string.

Follow along with Greg from 1:27
3. Make Your First Scoop Attachment
Bring the next mesh attachment up to your first top-string hole. The scoop knot uses two passes that sit on opposite sides of the mesh connection. Follow the green string in Greg’s close-up, keeping a little slack while you form each loop.
Take the top string and go through the first hole on the scoop, from the back of the head to the front of the head. Then, put your top string through the front of the mesh and toward the back of the mesh, but going over the string as you exit the mesh.
For the second connector, you will go through the back of the mesh first, and then come through the front of the scoop. Then, go under the loop of the string to lock in the top string.
Once both passes are in place, pull them snug so the mesh sits securely against the scoop. Take your time here. You’ll repeat this connection across the head.

Follow along with Greg from 2:01
4. Work Across the Scoop
Repeat the same attachment at the remaining top-string holes, keeping your mesh spacing even. The setup shown uses four scoop attachments, with the mesh centered between the two side anchors.
Tighten each connection as you go. Before moving on, check that the mesh sits evenly and that each knot is formed the same way.

Follow along with Greg from 2:40
5. Finish the Other Side
When you reach the opposite side, secure the last outside diamond to the matching sidewall hole. Mirror the starting anchor and tie off the string securely.
You will go through the back of the mesh and take your string from the inside to the outside of the sidewall hole. Then, move back around the back of the mesh and out the same sidewall hole to complete the loop.
Give the mesh a gentle pull and check your work. Both side anchors should be tight, the scoop knots should be snug, and the mesh should sit centered in the head.

Follow along with Greg from 3:38
Before You Move On to the Sidewalls
Look across the scoop and check that the mesh is centered, both side anchors match, and there’s no loose string between connections. If one spot looks loose, work the slack out now.
Once everything is tight and even, you’re ready to start the sidewalls.
Leave a comment